how to create a boolean difference between insole floor and parallelepiped

[backintime]

Good morning.
I can't create a boolean difference between the solid floor, the insole and the parallelepiped to get the result in photo. specific that the solid of the floor was obtained by extrusion of a 3d polylinea while the parallelepiped was created by extrusion of a flat surface.
allego 2 photos corresponding respectively to the first and after.
Can you please help me?

 

[Tristan]

Are they both solid?

 

[backintime]

Are they both solid?

Good morning, thank you for your kind answer.
making a List solids are obtained by extrusion with the exception of the insole. The latter is a solid "sun".
for completeness I also provide you with instructions to generate 3 solids, to facilitate verification of members of this forum.

draw on the xy plane a polylinear through the following points:
1. x= 0.00 y= 0.0000 z= 0.00
2. x= -24.00 y= 0.0000 z= 0.00
3. x= -24.00 y= -6.85 z= 0.00
4. x= -90.86 y= -6.85 z= 0.00
5. x= -90.86 y= 32.57 z= 0.00
6. x= -73.72 y= 32.57 z= 0.00
7. x= -73.72 y= 22.28 z= 0.00
8. x= 0.00 y= 22.28 z= 0.00

extrude the polylinea of 2.75 meters compared to the negative direction of z.

Starting from the coordinate point x= 0.00 y= 0.00 z= 0.00 (considering it as an extractor of a insole) create an insole on the xy floor of a thickness of 0.20 meters, along the perimeter of the polylinea.

in points . x= -1.37 y= 1.37 z= 0.20 and x= -8.57 y= 20.57 z= 0.20 create a flat surface, on the xy plane. extrude the surface creating a solid parallelepiped of height 2.74 meters in negative direction of the z axis

 

[Cristallo]

to carry out Boolean operations, that I know, in autocad it is necessary that the solids on which to operate are all generated by extrusion of flat figures closed the basic type (circles, polygons, polylines etc.).
Other types of figures such as mesh, regions, faces once extruded do not generate a type of solid on which boolean operations can be carried out.
pass the insole along its edge with a beads and extrude it, should not trouble you.

p.s. I tell you about pure autocad, but adt should be nothing but a pure autocad vertical, so logic rigor should work.

 

[Tristan]

other types of figures such as mesh, regions, faces once extruded do not generate a kind of solid... .

le regioni si! :wink:

 

[GP.]

anche le (3d)facce! :wink::wink:

 

[backintime]

to carry out Boolean operations, that I know, in autocad it is necessary that the solids on which to operate are all generated by extrusion of flat figures closed the basic type (circles, polygons, polylines etc.).
Other types of figures such as mesh, regions, faces once extruded do not generate a type of solid on which boolean operations can be carried out.
pass the insole along its edge with a beads and extrude it, should not trouble you.

p.s. I tell you about pure autocad, but adt should be nothing but a pure autocad vertical, so logic rigor should work.

Good morning, thank you for your answer. I should solve with the autocad architecture commands without circumventing the question.

 

[Cristallo]

architecture does not have the plinea or extrude command? I don't know him. .