LudovicaF99
Guest
Good morning, I am a design student of the industrial product and I would need to do this piece (it is a component of a bike). I tried with the blend sweep because I thought it was the most congenial, but nothing.
asblo
Guest
I do not use creo, but conceptually to model it you have to do revolution with the profile of the full cone trunk, then from the top view you make the 6 cuts to 60°, then you will make the support of the pedal with a sweep
Vittorio
Guest
@ ludovicaf99 you enrolled in cad3d Monday 1 February and at 11:35 you made a request for help that you were given 8 minutes after your request.
on the same day, you entered the site at 7:15 p.m. and then you disappeared.
Now: to claim a grace seems highly excessive, but at least to say that you have taken note of the data advice would benefit your education.
on the same day, you entered the site at 7:15 p.m. and then you disappeared.
Now: to claim a grace seems highly excessive, but at least to say that you have taken note of the data advice would benefit your education.