Zac69
Guest
Good morning, I created an ilogic rule that, after opening a part and launching it, creates a custom prodity called length and in which it inserts the greater value detected between x, y, z.
All right here.
But if I have a set, I must enter each part and launch this rule.
Does anyone know a system to select at the level of together the parts that interest me and throw that rule only on these?
inventor 2022.
Thank you.
All right here.
But if I have a set, I must enter each part and launch this rule.
Does anyone know a system to select at the level of together the parts that interest me and throw that rule only on these?
inventor 2022.
Thank you.