I'm not getting updated

[fenice consulenze]

Hello, guys, excuse the question, but it never happened to me that when I edit a part, I don't update the table.
I have been using pro-e for years and then I create and never happened to me.
Did I accidentally change any settings?
Thank you.

 

[320i S]

you have to have the update option seen manual, just reactivate that.

auto_regen_views

 

[fenice consulenze]

you have to have the update option seen manual, just reactivate that.

auto_regen_views

Hi.
I set with yes value the string you recommended and saved in the config. But it doesn't work.
My question is: is this option retroactive? in the sense that it is also valid for "old" drawings or only for the new ones that point me to the new config?

I never had such a thing happen to me and remake all a complex table mass because it does not update my eyes, it depresses me....

 

[320i S]

you are a retroactive option, you restarted create?, now I don't remember if it is one of those options, but some you have to force create because you activate.

but did you at least try the command views design->update view-> all sheets?

 

[fenice consulenze]

you are a retroactive option, you restarted create?, now I don't remember if it is one of those options, but some you have to force create because you activate.

but did you at least try the command views design->update view-> all sheets?

Yes, I restarted the program. of course some odds have jumped, but the profile is unchanged
Yes, I updated everything, but nothing... .

 

[320i S]

the jumped quota can have a thousand reasons, I would not worry about a quota, rather full views that do not update yes, what did you say in the chart "link references"?
If there are external mathematics recalled in the table, the question is a more complicated thread.

 

[fenice consulenze]

the jumped quota can have a thousand reasons, I would not worry about a quota, rather full views that do not update yes, what did you say in the chart "link references"?
If there are external mathematics recalled in the table, the question is a more complicated thread.

No, I don't have any related external mathematicians.
only the part

Don't worry, I'll solve this problem too....

 

[freexf]

open the drawing, then try to collect messages of horrors and warnings from the messaging bar and post here