f.dagnolo
Guest
Good morning to all,
I am using proes for the creation of a very complex detail and I take advantage of a procedure made by third parties, but it seems rather complicated and unfunctional.
the purpose is to load .pts files which are nothing but data of a trajectory in cylindrical coordinates in the project through a graph/spline.
made this using the command evalgraph I'm going to read the data in a recurring manner and make proe calculations.
Obviously this procedure is not associative: if I change the .pts files there is no way to update the spline if not by hand reinserting the new file.... .
I was wondering if it is not possible to upload the data directly into a proe table and from here read them directly, but I do not know in depth the cad commands.
Can anyone help me?
I hope I was clear...:wink:
I am using proes for the creation of a very complex detail and I take advantage of a procedure made by third parties, but it seems rather complicated and unfunctional.
the purpose is to load .pts files which are nothing but data of a trajectory in cylindrical coordinates in the project through a graph/spline.
made this using the command evalgraph I'm going to read the data in a recurring manner and make proe calculations.
Obviously this procedure is not associative: if I change the .pts files there is no way to update the spline if not by hand reinserting the new file.... .
I was wondering if it is not possible to upload the data directly into a proe table and from here read them directly, but I do not know in depth the cad commands.
Can anyone help me?
I hope I was clear...:wink: