impossible to open table

[brn]

good evening, suddenly I can no longer open a table of a set (of course 6 sheets a1 rich in quotas and mounting indications) I find the writing impossible to open file contact assistance. I already know that I will have to do it again, but I'm afraid that the problem could be resumed. is it an error that can depend on some problem of the aid and so if I put the table back I would risk losing it again or depends on the table or anything?

ps of course the assistance contract expired a few months ago and they did not want to renew it. . .

 

[MassiVonWeizen]

you tried to open it in mode light weight o Quick view?

 

[brn]

then the table after a half hour of attempts resumed to function normally. I don't understand what it might be, in doubt I made a copy in dwg....
I noticed that it was hard to open the top-level axiemi boards that contained that axieme.

I don't know any of the two methods, I tried to look for quick view and I see it allows me to open a sheet at a time in a way
simplified, while light weight boards do not know anything

 

[MassiVonWeizen]

Quick view and I see that it allows me to open a sheet at a time simplified

this allows you to print a drawing not to remake the work from scratch since a large part of the work in the drawing is to reason on the views and quotas to put

light weight boards do not know anything

http://help.solidworks.com/2015/italian/solidworks/sldworks/c_lightweight_drawings.htm