imprecise display

[supertramp]

I have this problem since I use 9.0. first it was enough that I did a regenerate view and the view became accurate now instead I can not find the way to see the precise curves. Is there another way to increase visualization accuracy?
I have a picture and even if I act on the driver's antialias nothing changes. Can anyone help me?
thanks in advance !

 

[The_Matrix]

try to remove the parameter render solid using stored facet that stands under "visualization performance".
also take a look at the new menu "facet settings".

 

[The_Matrix]

just some clarification on the new menu of facet settings.. .
is the menu that explicitly guides the resolution used by nx.
inside the menu you will find the various levels (rough... standard... etc... ultra...) and, immediately below, the parameters that hold.
I normally use standard or fine, but accuracy depends on the bounding box size of the model, if you use the part as a calculation method.

 

[beppino]

I have this problem since I use 9.0. first it was enough that I did a regenerate view and the view became accurate now instead I can not find the way to see the precise curves. Is there another way to increase visualization accuracy?
I have a picture and even if I act on the driver's antialias nothing changes. Can anyone help me?
thanks in advance !View attachment 36488

in the visualization preferences menu - faceting:
I have the same problem as you.
setting view, regenerate the display properly.

 

[supertramp]

Thank you! :finger:

 

[Shaba]

I am with the same problem with a draft nx9
I practically have holes that are octagonal
How can I increase precision?
Thanks

 

[maria14]

I normally use standard or fine, but accuracy depends on the bounding box size of the model, if you use the part as a calculation method.