independent view

[mario.argese]

Hey, guys.
I contact you to ask if there is a method of copying a view (e.g. that of the ground floor) and making it independent, so as to draw on elements 2d and not upset the whole finished project.
I have to draw the electrical and water part in 2d, so I would need an independent view of the project.
is it possible to do all this?
I tried with the search button but found nothing.
I hope I've been clear enough anyway.
thank you in advance and greet you
:smile:

 

[emi_973]

I don't want to be wrong, but I think you can't... you should duplicate the view and then apply the display filters. tell revit that in your duplicate view you will not have to show you furniture, labels of areas and premises, etc... if you want them completely independent creates another file. But do you agree?
Bye.

 

[mario.argese]

they mentioned that from a view copied as an employee with detail, you can give a command that makes the view copied as an independent.
I just don't know how to do this.. .

 

[gfrank]

the command is seen > models view >crea model from current view
a dialogue mask is opened, which allows you to set all the characteristics of a view, in particular the graphic visibilty (of families), that is, you can "spegnere" some/all the categories of families (and subfamilies).

creates two new models:
a) the first, a model of view, which calls without an electric Irdic (with this name will be stored in the "view models") and by the graphic visibility "spegni" only the families of the electrical and water system


b) the second, a model of view, which you call with electric Irdic (with this name will be archived in the "view models") and by the graphic visibility "spegni" all families, except the families of the electrical and water system

normally draws on the default view /view all your project, including plants.
now, to “see” (set) the views as you need, duplicate the default views you need (we use as an example the plan views)
by duplicating the view of the ground floor (renewing: pt- plants) to see represented in the same only the plants you have to assign to this view the model (of view) referred to in point b) by means of the commands : view> models view > apply model to the current view > and select the name with electric Irdic from the list of the models of view

to create a view without plants, but with everything else as indicated in point a) you have to duplicate again the view of the default ground floor (renewing: pt- without implants) to see in the same all less the plants you have to assign to this view the model (of view) referred to in point a) by means of the commands : view> models view> application model to the current view > and select the name without electric view from the list.

proceed in the same way for other types of view (sections, brochures, 3d, etc.)

re-epiloating, you will have for every type of view 3 models (view):
- a default, which you use to draw, with all families
- one with only plants
- one with everything, without plants

saving these view templates, in the starting template, can be reused for each project

 

[mario.argese]

but there would be no command or procedure that the view of the ground floor, for example, copy it to me in a new view but in 2d.
Could you do this or something?
I say that because my friend had told me about this...
sin that I can not + contact him. . .