indications centering hole: mechanical symbol and regulations

[Vit1]

Good evening!

I have a problem finding the legislation uniso 6411 relating to centring holes (simplified representation of center holes). I should insert the special symbol instead of the detailed representation but I can't find it (it seems to have looked everywhere, but maybe I looked bad). the guide for the moment did not help me and I managed only to represent the un schematized hole.

a note: I found myself inserting 3 new discussions in no time. since I think it's arguments that those who approach the software must first or later break their heads (no documentation is found, at least not with google research or the guide I did) I think it's right to open separate discussions so that everything remains more readable. If this were contrary to some forum rules, let me know, and maybe I join everything in one discussion. Thank you!

 

[GiGa]

I should insert the special symbol instead of the detailed representation but I can't find it

dx key on hole, properties, check box "representation"

a note: I found myself inserting 3 new discussions in no time. since I think it's arguments that those who approach the software must first or later break their heads (no documentation is found, at least not with google research or the guide I did) I think it's right to open separate discussions so that everything remains more readable. If this were contrary to some forum rules, let me know, and maybe I join everything in one discussion. Thank you!

That's great.

 

[Vit1]

Thank you so much! I solved perfectly as indicated by you (drawing to symbolic representation).