info taglio laser

[omarsar]

hi to all hope to be in the most pertinent section.
wanting to buy a laser cut sheet someone has experience on the operation of the laser mazak co2 type the stx 510 ? in perticular I refer to the management of the x axis that happens by handling the board ... some argue that the sheet could move causing errors in the geometry and loss of precision on the processing. Omar

 

[meccanicamg]

Well... I would say that if you change the table so that the sheet is fixed, it sure does not run if you move the x axis with strong accelerations.

 

[omarsar]

Well... I would say that if you change the table so that the sheet is fixed, it sure does not run if you move the x axis with strong accelerations.

Thank you ... I "dribbled" the problem ... I boughtnun trumpf;-)