inserire un jpg

[reggio]

Hello everyone, I would import a jpg image and then recalculate it, with the old acad14 it was very simple, now with acad2010 I can not find the way... the help explains how to import using images for icons but I don't need that.. .

enter/import instead does not accept jpg....

is it not possible anymore or am I not finding the right way?

 

[lattu]

You want to tell us you worked until yesterday with the r14??? Amazing!

menu insert > image raster

 

[liber]

You want to tell us you worked until yesterday with the r14??? Amazing!

Why unbelievable?

do not believe that users of autocad 2010 and 2011, fully exploit the possibilities that from the software.
personally I had a suite that turns around autocad14 or better was mechanical 14 addcad to make drawings of buildings in 3d, and autocad overlay now raster design)
without counting the various lisp of kit

many innovations could bring them with autocad 2000, instead of dragging them little at a time until now, and I refer to the transparencies in the layers already active on microstation that supported the same graphic motor of autocad, to the subject pdf and dwf, for the rest the 3d sure it is greatly improved, but in rhinoceros the 3d is much more flexible and fast than in autocad
then while wanting many meridian software of the geotop, the dxf that releases the agency of the territory, are of version 12 of autocad.
therefore 90 % of the work that was done with autocad 14 remained unchanged as methodology until the 2011 version, to obvious exclusion for vertical autocad packages, type civil and map, although some options of map as import of various georeferential images it was possible to have them with autocad overlay

 

[reggio]

ciao

You want to tell us you worked until yesterday with the r14??? Amazing!

r14 always regretted;-p

menu insert > image raster

but you see it in my image

 

[PlannerRoad]

Hi.

r14 always regretted;-p


but you see it in my image

command attackimm or even image.
lattu in fact spoke of menu, not of ribbon bar.
What you indicated are the ribbon bar cards.
to view the menus above the ribbon bar tabs, where there is that menu bar above, find a curtain, if you open it will appear "show menu bar".
In any case, you find "allega".

ps: it is always good to see the online guide! !

 

[reggio]

to view the menus above the ribbon bar tabs, where there is that menu bar above, find a curtain, if you open it will appear "show menu bar".
In any case, you find "allega".

ps: it is always good to see the online guide! !

Thank you very much
I didn't find the right "key"...

Can I ask you something else? Now that I have the image, could I make it semi transparent and "impalpable" so that I can draw it over with autocad?

 

[liber]

the transparencies only with autocad 2011, to recarlcarla, it is not better not to have it transparent, impalpable?, that is with the original definition.

 

[reggio]

the transparencies only with autocad 2011, to recarlcarla, it is not better not to have it transparent, impalpable?, that is with the original definition.

I wondered why I found the image above the design cad, I drew the lines but I did not see them:

cmq going a little blind I solved:d

 

[liber]

it was not then difficult to go on display order and put the image below