insert part that you visualize in a certain way...

[m_arquati]

Bye to all,

I should insert a part (saved as part, or smart component...) that in the axieme (or in the multibody part) does nothing, i.e. it appears normally but in the drawing at the table should appear as a cross.
I need laser tracks to insert threaded pins.
in the track for the laser, where a cross is encountered, the laser draws a cross that indicates that I have to shoot the threaded pin.
I tried to make a smart component that practice cross cut thickness 0.00001 but the laser realizes that it is a double line and not a single!!! !

thanks for the help
Mar

 

[cacciatorino]

I tried to make a smart component that practice cross cut thickness 0.00001 but the laser realizes that it is a double line and not a single!!! !

thanks for the help
Mar

Can't you do a sketch and see it when you make the table?

in solid edge then I know that there is a special level to make sure that when exporting to the laser cutting machine certain lines are used only to make engraving and not cut, you should see how to do the same thing in swx. I unfortunately have no experience of sheet metal.