interference analysis with tolerances

[ilyanor]

Good morning to all, I would like to know if there is a function of analysis of interference between parts that have been assigned specific tolerances.
I'll explain better. "interference analysis" is able to detect only interference in case the nominal diameters of a shaft hub coupling are different. if instead I check the same diameter, but tolerances that create interference, inventor does not recognize it.
Is there a way to implement the analysis?

 

[eugenesis]

In the given tolerance, you must apply the deviation or calculate the actual value of the model
if you check in the parameters pane (fx) you will see that there is its own column.
Then go with the interference analysis.