interpretation of article 16742

[Nibbio4]

Hello everyone,

I have a doubt about the rule din16742 on which to use 2 tables (Table 2 and Table 9). Since the value of tolerance changes a lot in size.

Has anyone been confronted yet?

Thank you.

Hi.

 

[meccanicamg]

I have always seen only one that is on all manuals and has never changed. using 3d programs calculates it alone then zero problem. Are you sure you read the tables right and do the right accounts? or have a hand updated and correct version?

 

[Nibbio4]

There are 2 tables, table 2 and table 9, now I do not have them to describe them, Monday I will be more precise.
the previous norm had only one table