interrupted bevels

[power23]

Hello guys, you can make a bevel along a edge...but interrupted to a certain length.
If they select the proe edge by default, select the entire length...but if you want to interrupt it first?? Can I? ?

Thanks

 

[Prof.]

Of course, the procedure is this:

• put a referment point or a plan where you want to stop the bevel
• create the bevel by selecting the edge
• inside the bevel command press the "pass mode transitions" button (second key from left
• select the end of the bevel you want to shorten
• choose "reference stop"
• select the point or the previous plan created

ciao.