riccardo.toscani
Guest
Dear users,
I was never worried that I could not see the section of a component imported from the center (in this case a screw) both on table and on a section view on a set. But now I have to show a particular that goes on top of the screw but nothing to do is not seen. Is there any setting to do to view the section of the imported components from the inventor's content center?
allego photos
for precision is an o-ring that must fit the screw.
thank you rich
I was never worried that I could not see the section of a component imported from the center (in this case a screw) both on table and on a section view on a set. But now I have to show a particular that goes on top of the screw but nothing to do is not seen. Is there any setting to do to view the section of the imported components from the inventor's content center?
allego photos
for precision is an o-ring that must fit the screw.
thank you rich
