aerox
Guest
Hello everyone, we have recently started using swx to model our products, they are essentially containers with welded connectors, anglers, and in some cases oil separation filter and internal sheet diaphragms.
I wondered, can you set a simulation to optimize the product??? for now it has been mentioned only of the loss of load, but other fundamental parameter that would be nice to get would be oil/gas separation.
the fluid that enters there is a mix of oil lubricant/gas for cooling, and I would like to understand how oil particles behave inside. which program is suitable for doing this?? ?flow or simulation? ? ?
thanks to all
I wondered, can you set a simulation to optimize the product??? for now it has been mentioned only of the loss of load, but other fundamental parameter that would be nice to get would be oil/gas separation.
the fluid that enters there is a mix of oil lubricant/gas for cooling, and I would like to understand how oil particles behave inside. which program is suitable for doing this?? ?flow or simulation? ? ?
thanks to all