radio
Guest
Hello, everyone.
I should do a little "criminal" operation, but I don't know if it's possible.
in poor words I should display in table 2d a 3d model that has "sticked" a sketch that in turn incorporates an image (see below):
in the table I can't show the image, even if in preview you see; I see only the box:
Does anyone know if there is a way to do this?
n.b. to the bad parade I insert another time the image directly in the 2d, but it is an acrocchio; I would like to represent the complete 3d model of embedded image.
a thank you in advance to those who will answer.
I should do a little "criminal" operation, but I don't know if it's possible.
in poor words I should display in table 2d a 3d model that has "sticked" a sketch that in turn incorporates an image (see below):
in the table I can't show the image, even if in preview you see; I see only the box:Does anyone know if there is a way to do this?n.b. to the bad parade I insert another time the image directly in the 2d, but it is an acrocchio; I would like to represent the complete 3d model of embedded image.
a thank you in advance to those who will answer.