laser printer and prints not responding to drawing

[mandolakis]

Hello, everyone.
I have a problem with the new laser printer oki830.
the printer is equipped with ps and pcl driver.
but when I mold a file of acad the full net I print it in very close rows, like a thick dash, and also the gray writings does not make it "piene" but type dotted.
Could you give me some advice?

Thank you.

 

[PlannerRoad]

tried to set in printer drivers a high quality print mode?

 

[mandolakis]

I tried, but if I imposed the options for a high quality image it actually makes me full of solid retinals and the gray makes me full, but the dash type ansi31 if he handles it and prints the thickest bands and the less dense bands.

 

[PlannerRoad]

tried out of curiosity to print in autocad first in pdf and then send in print that?

 

[mandolakis]

I tried as you suggested but I have the same identical results.
or I print the full retino and take off the restraint, or treat me with the full retino and the gray writings and keep me good the dotted retino.

 

[Ezio Olivato]

Have you tried with acad .ctb standards?