length spline

[nicnoc]

quotating the length of a spline is possible?

 

[nicnoc]

Sorry, I was a little cryptic. I have to divide a spline in n strokes each having length 2 meters (not distance between points, but the integral curviline between two successive sections). I just have no idea how to do it. I thought to approximate the spline in the sum of several arches and then subdivide the arches according to their angle opening but it is very slender.

 

[Mocca]

Sorry, I was a little cryptic. I have to divide a spline in n strokes each having length 2 meters (not distance between points, but the integral curviline between two successive sections). I just have no idea how to do it. I thought to approximate the spline in the sum of several arches and then subdivide the arches according to their angle opening but it is very slender.

Bye.
inside the point creation command (out of the sketch) there is the possibility to create a distant point x mm from the pre-selected one. you need to enable the "geodesic" function that is what you do for you, while the "euclidea" creates distant points x mm but in "cordal" mode.
at the bottom of the "point" command options you have the possibility to perform repetitions, in this way you can create n points apart from each other x mm and "drop on the curve.

after creating the points you can cut the curve over the points you generate, thus creating the curves you need.

we waved

 

[panormus]

Thank you very much.. I didn't know. keep following you:wink:

 

[nicnoc]

Yes thank you very much, I had actually thought of a solution similar to that... I just thought there was some different command.

Thanks again. Good evening