lift/low level

[Maxweb]

good morning, I do not often use the command component>low / high level and therefore I do not know well the operation.

in the specific case I have a set of parts and sub-assiemi. with the command raises level I take some parts of the assieme father is the included in a new one under together. But I can't put a part on an existing subset.

someone can help me? I use inv 2015.

thanks and greetings.

 

[Ilario]

you drag it in your browser

 

[Maxweb]

you drag it in your browser

thank you, I had not expanded (+) the axieme in the browser and therefore did not leave me "incorporate", to the second attempt .... ok.

Say hi.

 

[rizzifrizzi]

you drag it in your browser

Does anyone know if there is a simpler way than dragging into the browser? I mean when the parts to be lowered are very far from the axieme where you want to go to put it is easy to lose sight of the final point where to drag them. . I imagined that over the years they made possible the direct drag from the modeling graphic window (checking directly the interested parties) in order to be able to drag them where it interests within the browser.. But it doesn't make me.