lighting assembly

[coquin]

Good morning, everyone.
I apologize if I annoy you with a trivial matter, but it's been a while since I don't use nx5 and I can't find any more where the annoying lighting of the assembly components is disabled when you walk with the cursor over the maths.

even with high-performance machines, in case of very large assembly slows down all processes.

Thank you.
Hi.

 

[interno15]

preferences -> selection... -> e togli il flag su "highlight selection on rollover" :wink:

...credo sia questo a cui ti riferivi!

 

[coquin]

thanks for the internal response15.

the problem is that with the suggestion you gave me, they do not illuminate + even entities like edges when you have to select them.
On the other hand, I remember that with nx3 there was a setting that only acted on assembly and not on selection.
Unfortunately, however, I spent a year in catechism and forgot almost everything...
so I can't understand if I can't find it or if in nx5 there's no more, maybe it's going to happen to reinstall the 3 to see what I was doing, probably in front of the old menu will come back in mind...

It is obviously not a matter of fundamental importance.
Thank you
Hi.

 

[IPdesign]

Have you tried to set as a filter in the selection bar from "full set" to other?

 

[coquin]

fantastic!!! thanks to the intuition of ipdesign I managed!!! :finger:

go to "detailed filtering" and disable components.. .

so when the cursor passes over the entities they light up except to illuminate the whole components.

I think it might be a useful suggestion to all those who like me work with large assemblies that every time they put us a very annoying time to become red and regenerate.

thank you all, soon.. .