limite linee di piega

[masspa]

Hello, everyone.
speaking of sheet metal I have a small problem regarding the fold lines that are created automatically in the table.
is it possible to make these not come out of the piece?
use creo4.0 m010.

That's what makes me. .
while I need them to come like this, with the line that doesn't come out of the perimeter of the piece.
Thanks

 

[Prof.]

in the design you can set the option axis_line_offset a .
only that so also the axes of any holes or extrusions will have the same height of the processing.
Bye.

 

[masspa]

That's exactly what I was looking for!