lines development sheet

[xxfast]

provided I am quite rusty with catia and my version is v5 r20:
In the attached part I can't view the fold lines in the table setting on drafting.
Could someone explain to me if there is a way or a mistake?
It seems that in sheet metal parts obtained from emptying solids or surfaces I always have problems with the fold lines.
Thank you.

View attachment Serbatoio parte 2.rar

 

[magic]

I have the r17. Don't open the file! I'm sorry

 

[xxfast]

I assume that the only way is the ancient one to redesign the part... :tongue:

 

[railroad]

I assume that the only way is the ancient one to redesign the part... :tongue:

In fact, redesigning everything, the developed projection is inclusive of fold lines.
Given the simplicity of the piece, I recommend that you do it again:finger:

 

[xxfast]

In fact, redesigning everything, the developed projection is inclusive of fold lines.
Given the simplicity of the piece, I recommend that you do it again:finger:

in fact it is the best thing.
only that we are in prototyping farse again and then I wanted to do something fast and then perfect.
However I have identified the error and now it works.

 

[railroad]

What was the mistake? Is that a set?
I think it might be useful to the forum if I explained the thing... :smile:

 

[Joshua662]

Good morning

in the right-click drafting environment in the window where you present drawing 2d and selections from the property menu and from the next screen select the axle option.

 

[xxfast]

What was the mistake? Is that a set?
I think it might be useful to the forum if I explained the thing... :smile:

practically was a final edge of a wall that remained oblique after emptying.
I missed the detail. ..it had to make a cut to rectify and perform the recognition.
View attachment esempio.rar