mullah
Guest
Hi, I'm new and I'm at the top of the program. when I go to insert the local contour of the area partially covers the masonry section..about half.. is there a way to change this setting? Thank you.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
gfrank
Guest
Welcome to the forum.
remember to insert the discussion in the correct forum. this, dealing with a topic of the sw revit, I moved it to the specific forum (revit)
remember to insert the discussion in the correct forum. this, dealing with a topic of the sw revit, I moved it to the specific forum (revit)
mullah
Guest
Yes, if I subsequently noticed that I was wrong. Thanks :finger:Welcome to the forum.
remember to insert the discussion in the correct forum. this, dealing with a topic of the sw revit, I moved it to the specific forum (revit)
gfrank
Guest
... the command (local), being automatic, does not allow any revision of the boundary lines ...
mullah
Guest
Thank you very much