lock a command.

[paolo_go]

Hey, guys, I got a little problem. I am modeling a particular quite complex, and it happened that while trying to stretch a surface I probably set a too high elongation value and the cad is 15 minutes trying to calculate but it just doesn't make it...
I would bring down the ugraf.exe process but I would lose some work.

Is there a possibility to block the command without dropping the program?

I hope you're not all on holiday.

Hi.

Palo

 

[The_Matrix]

Hey, guys, I got a little problem. I am modeling a particular quite complex, and it happened that while trying to stretch a surface I probably set a too high elongation value and the cad is 15 minutes trying to calculate but it just doesn't make it...
I would bring down the ugraf.exe process but I would lose some work.

Is there a possibility to block the command without dropping the program?

I hope you're not all on holiday.

Hi.

Palo

once, on unix, you could... Now I think you can't anymore.

 

[axa]

once, on unix, you could... Now I think you can't anymore.

ctrl+shift+l ?

 

[paolo_go]

I have to kill the ugraf.exe process and do some work, patience... next time you plant on a command, I try with ctrl+shift+l.

thanks axa

Hi.

 

[The_Matrix]

I have to kill the ugraf.exe process and do some work, patience... next time you plant on a command, I try with ctrl+shift+l.

thanks axa

Hi.

ctrl+shift+l was the x kill mode the command on unix.
was replaced by the "stop" button, but it doesn't always work (not all commands support it).
for nx8 are working to extend and improve support to the "stop".