loft?

[TECNOMODEL]

How would you close the area you see in the annex?I'm trying with a loft but uselessly...
My problem is that the hole must remain, I must "connect" the edge of the hole with the inner part that is shaped and I do not jump out.

 

[Catafratto]

Can you post the part?

 

[il teo]

Good morning.
does not loft do it (as surface)?
then there should be a tool (such as sculpt or merge) that should create the solid from the surface.
If I could train the part, I'd play it a little bit.
greetings

 

[TECNOMODEL]

Thank you very much.

I didn't think of lofting as a surface and joining the solid.

I don't have the habit of these commands.

Thanks again