Valerio19
Guest
Hello everyone, I'm a crate mechanical engineering university. I have already consulted the old posts in the forum, but I couldn't understand how to represent the threaded organs in the conventional method.
checking a tutorial that you have attached for a student of my own faculty, I noticed that it was present in the tutorial the difference between the uni 5625 representation and the conventional design and the measurements marked for the conventional representation are different from the first (always if you have not understood bad). Please, can you tell me how to get those measurements and in case you misunderstand the tutorial, how to do the exercise I attached?
I'm sorry for the trouble, but I'd like to take this exercise as soon as possible since it's the only one I couldn't complete.
checking a tutorial that you have attached for a student of my own faculty, I noticed that it was present in the tutorial the difference between the uni 5625 representation and the conventional design and the measurements marked for the conventional representation are different from the first (always if you have not understood bad). Please, can you tell me how to get those measurements and in case you misunderstand the tutorial, how to do the exercise I attached?
I'm sorry for the trouble, but I'd like to take this exercise as soon as possible since it's the only one I couldn't complete.
