mad inventor

[Michelefi]

I am in the environment together and after putting a bond it no longer binds me anything, if I want to put another one gives me error..in practice with only one bond is in balance! !

 

[Ilario]

difficult.... maybe provide some extra details about what you are doing and possibly post an image

 

[Michelefi]

thank you for the answer...the problem is that it makes me put a bond, then when I try to drag it comes to me the symbol of "divide" and it does not move,as if it were completely bound!...maybe when I get to work place a photo

 

[essebi]

is because there is a mistake in some part nested so it can't solve the axieme, go up in the quick start bar, you will see a red cross, if clickcki will show you the detail of the error/error

 

[Michelefi]

Thank you very much!!! ! ! ! ! ! ! ! ! ! ! ! ! ! ! !

 

[Michelefi]

is because there is a mistake in some part nested so it can't solve the axieme, go up in the quick start bar, you will see a red cross, if clickcki will show you the detail of the error/error
View attachment 35890

I have eliminated the error but continues to do so...... (

 

[MauroM]

Do you have any adactivity? If yes, try to eliminate them.

 

[bradipo666]

cursed adactivity. They only cause problems. .

 

[ValvMax]

mmm more than problems should be applied preferably on multibody or where you know that the part will not undergo changes or substitutions but are useful in the most desperate cases

 

[Michelefi]

Thanks to everyone, however I thought I had resurfaced instead I keep giving error(red crotch),so it must be for that