make solid set surfaces

[TECNOMODEL]

in inventor there is a command that allows me to transform a group of surfaces into solid?

I have a step model sent to me from the foundry, I corrected errors, in the browser appears the "composed" node with green flag.
So it's okay.

the problem is when I go to the table, in the section I see the inner side of the surfaces.

 

[batstar]

Do you sculpt surfaces?

 

[TECNOMODEL]

I didn't imagine finding him in that command.

It's what I needed, it's too bad that that file doesn't work.

Does anyone have any idea how to solve this?
I have this imported step file, it is a compound of surfaces.
correct geometry, in the browser I have the node "correct geometry".

But I can't make it solid.

 

[batstar]

I didn't imagine finding him in that command.

It's what I needed, it's too bad that that file doesn't work.

Does anyone have any idea how to solve this?
I have this imported step file, it is a compound of surfaces.
correct geometry, in the browser I have the node "correct geometry".

But I can't make it solid.

I have never been able to transform a set of surfaces from a step into solid, or I can not use well inventor, or it is the program that does not digest surfaces well.

 

[eugenesis]

If you bring it to "construction" , separate it, check it, see where it is opened, put the patches you need,
Then you do the stich, then you bring it back to modeling. .

 

[Tarkus]

I have always used the command "join surfaces".
It almost always works. . .

 

[Zac69]

I carry it under construction, then I separate everything, I do a verification and then I join. If it's okay, I've got the solid, otherwise I'm satisfied or I'm screwed. . .

 

[eugenesis]

. I'd say you're not screwed. Look where the defect is, and then replace it.
if needed, then join and solidify..

 

[Zac69]

. I'd say you're not screwed. Look where the defect is, and then replace it.
if needed, then join and solidify..

depends. If the problem is missing flat surfaces, it will remake them and join them, but if the file starts to have overlapping surfaces, missing connections or some other rock I try to send the file back or I remake it by modeling it so that there are the faces and the holes that serve me and I release the rest.

 

[TECNOMODEL]

What do you mean, "I bring it under construction"?

If it's the "bodies regiment" I've already done it. eliminated errors, gives me correct geometry.
However, it is not a solid but a compound of surfaces.

 

[eugenesis]

the construction environment must be enabled in advance by --> tools --> options;
is the old environment (not parametric outside the browser historian) that allows you to manage corrections as an alternative
to correct bodies; you can manage your data selection groups to turn on, turn off, partition and circumscribe problems etc.

If it is a compound of surfaces and not a solid, it means that there is an opening between inside and outside.
under construction with check see the edge colors and understand where it is such opening to close with change tolerance or
boundary patch to get solid

 

[Tarkus]

the construction environment must be enabled in advance by --> tools --> options;
................................................................... .

tools --> options and then? I can't find him. .

 

[il teo]

here should be explained:http://help.autodesk.com/view/invntor/2016/ita/?guid=guid-70c282a1-dc14-429e-919a-0c16a99bb569

 

[Zac69]

tools > options > part > building environment enabled (top to right)

 

[Tarkus]

tools > options > part > building environment enabled (top to right)

Okay, thanks.