malfunctioning block with attribute

[pluncake]

Good morning to all,
I find myself a strange situation, I made a block to indicate in planimetry the planimetric quota,
I put an attribute where to write the quota. everything works apart the 1:50 scale that makes change
distance between the text of the quota and the circle of graphy. scale 50 is the only one suffering from this problem.
I can't figure out why, can someone get over it? Thank you.

attached the dwg file version 2013

 

[Superpippo33]

give the command [Modifbloc]select your block, write down the text, select the annotation scales for the text (the text of your block is not annotative).
save and close.
give the command [Sincatt], select your block, it should work.

Let me know how it went.

 

[Superpippo33]

try this, with a small variant to scale it.
View attachment blocco annotativo.zip

 

[pluncake]

It's just like you say, but I didn't understand why that anomaly only on that scale.
I also practice your version, now I try to see the one we find best with. Thank you!

 

[Superpippo33]

I don't know how autocad works, but in the file you posted there was also another factor to check: you scaled the block of a factor of 0.50. I don't know how it affects, but climbing it as I proposed, I noticed that there are no problems that manifested your block.

 

[Superpippo33]

the scaling you made it through the property panel. by parameterizing the block, it seems to go better!