management "configurations" together with sheets

[FRANKMARTIN]

Good morning to all,
for work needs I created, using the ipart tool, two sheets with two configurations : folded and laid
At this point I put the two pieces in question in a set, but I can't manage the two configurations:
piece b : folded
piece b : spread

probably have to use the iassembly command?
I can't help
Can anyone help me?
Thank you.

 

[Matteo Cappelli dis.CAD]

Hi.
no, you just have to activate with the dx button inside the axieme one or the other configuration
3d of example

 

[FRANKMARTIN]

Hi.
no, you just have to activate with the dx button inside the axieme one or the other configuration
3d of exampleView attachment 52297View attachment 52298

thank you 1000 for the answer
Perhaps I have explained badly, as you say, from time to time you have to change the configurations of the individual pieces, I would like to create two sets of assemblies, also because then I have to manage the table with views in stretched sheet mode and others in folded sheet mode

 

[Matteo Cappelli dis.CAD]

No, it doesn't work.
you need to load the sheet 2 times, once folded and one no
Therefore you will have to do visual representations where you turn on and off depending on the cases one or the other. of course for the distinct, it is necessary that in the active options the filter representation of together + option of the calculation quantity, otherwise it counts 2 pieces

 

[FRANKMARTIN]

No, it doesn't work.
you need to load the sheet 2 times, once folded and one no
Therefore you will have to do visual representations where you turn on and off depending on the cases one or the other. of course for the distinct, it is necessary that in the active options the filter representation of together + option of the calculation quantity, otherwise it counts 2 pieces
View attachment 52302

Thank you.