mass cartilage < > view

[leggera]

Good morning.

I put in the table a set and in the cartiglio appears the mass of the 1st positioned view.
Now I would like the mass to be referred to another view that is has another model state of the same table.

in a few words make the main view later.

Is this switch possible?


Thank you.

 

[Peppe]

in a few words make the main view later.

I create a new sheet - first copy the view I will determine as main (to which the table will refer) then in cascade I cover all other views. Finally I delete the sheet that I do not care.

 

[leggera]

excellent procedure thanks.

However it is strange that there is no possibility to change the main view or connect the mass to a chosen view.

 

[Peppe]

having different views for different configurations in the same file can cause problems.
the right thing (in theory) would have n designs or sheets for n configurations

 

[batleo]

I create a new sheet - first copy the view I will determine as main (to which the table will refer) then in cascade I cover all other views. Finally I delete the sheet that I do not care.

I also follow this procedure

 

[batleo]

excellent procedure thanks.

However it is strange that there is no possibility to change the main view or connect the mass to a chosen view.

would be suggested in the "ideals" and hope in new versions

 

[dsw]

News has already been suggested in 2017We just have to wait. . .

 

[Peppe]

News has already been suggested in 2017We just have to wait. . .

Perhaps the "great artificial intelligence" will help us "

 

[dsw]

@peppe .... then I'm quiet... sooner or later... :unsures: .... maybe... but maybe? :