mating quota

[estrOso]

Bye to all,
I would like to make a quotation of this kind :

Does anyone know if it is possible, in pro-and 3, to move below the quota line the text of the size?
of course only some not in general for the whole table

thanks for the attention.
Loire

 

[AMinati]

test by inserting a blank row over the size (turn button) should work

aminati

 

[estrOso]

test by inserting a blank row over the size (turn button) should work

aminati

works for notes but not for :frown quotation:

other ideas?

 

[thor105]

question: but what does a note like that use? is it not enough to put tolerances on individual details?
beyond all, if I don't remember badly, such a quotation is not even very orthodox.

 

[estrOso]

What note are you talking about?

I just want to quote a hole-shaft couple with one share instead of two...

 

[Alberto.E]

if you want to reproduce the example you have attached just add the text
of the additional quota under the nominal one.
the problem is that the shaft/hole coupling odds refer to the diameter not to the length.

 

[estrOso]

if you want to reproduce the example you have attached just add the text
of the additional quota under the nominal one.
the problem is that the shaft/hole coupling odds refer to the diameter not to the length.

hi, your method works but compels me to insert quota value and hand tolerances.
my idea was to place two odds on the same line, one with the value above and one with the value below.

As for my example, I entered the first "double" quota image that happened to me... this below is more indicated but the juice does not change.

Thanks anyway for the interest.
Hi.
Loire

 

[thor105]

What note are you talking about?

I just want to quote a hole-shaft couple with one share instead of two...

ops, I thought about it and wrote note.
for what I remember (you know, the age advances) of the norms for good technical design, the quotations relating to the tolerances of the details must be placed in the design of the individual detail, while on the drawings of assemblies must be inserted quotas and tolerances relative to the work carried out on the assemblies and encumbrance of the same.
That's why I said your way of listing didn't seem very orthodox.

 

[estrOso]

Now I understand...
^

In any case, for some couplings or welding assemblies, it is customary of the company to switch to the workshop single tables.

returning to the problem, if I did not understand badly there is the possibility to set a double quota... Does anyone use it?

 

[Alberto.E]

At this point I think it's impossible to do what you ask.