mechanical control display

[reimada]

Hello everyone,
these days I passed from mechanical 2009 to 2010.

I can't find the proper mechanical controls.. I basically see only those of autocad standards.

Can someone tell me why? !

ps I did the test by manually launching a command and it only works I have no menu bar or anything else that allows me to launch them.

 

[GiGa]

have you tried to unhook a little with the customization of the commands and insert the tabs/palettes that interest you (right on the palette and customize)?
Otherwise you may not have uploaded the menu... carmenu command loads ampp (it seems to be this, otherwise it is amacad).

 

[reimada]

I recontext the whole question.

This is the situation. I have 4 pcs with autocad mechanical 2010 installed. I wanted to share the same customization file between all pcs. so I took the customization file on one of the 4 pcs and placed it on the network on the company server.

I did this so that all four dots to the above file.

and now I am in this situation, the pc from which I took the file works perfectly. the other three see the customization file and its working areas etc. the menu is loaded missing some icons and especially when I go on some sections of the menu mech goes wrong.

help me please.. if I want to share the customization file it is no longer enough to share the file cuix as it did until 2009? (in 2009 mech had extension to which and not cuix but I think it is more or less the same)

 

[Superignazzio]

not the same
the extension of the file to which is cuix because you can use it with the autocad apploatives 2010 2011 and 2012, on you must absolutely load a .cui file of the version 2009 in customization of the version 2010.
if you do this autodesk has followed the windows solution, in the office 2007 the files have the same extension with the addition of the final x (.pptx is the power point file 2007)
I think you need to remake the customization file with .cuix extension, so in 2010, and then only share that

 

[GCF]

Hello everyone,
these days I passed from mechanical 2009 to 2010.

I can't find the proper mechanical controls.. I basically see only those of autocad standards.

Can someone tell me why? !

ps I did the test by manually launching a command and it only works I have no menu bar or anything else that allows me to launch them.

listen to reimada; I use mechanical 2008 ita. I tried to learn it using it. I believe from that little I know, that if you go on customize with right clik in the toolbar (where there is "save" or "copy" etc. at the bottom of the drop-down menu, find "customize". find them amcad, ampp, amfly.
amcad or ampp should give you all the possible commands; especially amputated
I hope I helped you. If you don't, I'm sorry.
hi, gcf (cuor di coniglio)