mirror placed in the table

[Lacry77]

Good evening to all
I need to mirror a wall on an already listed table
I have already done a mirrored derivative part but obviously so I have to remake the.messa at the table ... it is possible to double the table saving it with new name and in the new one to make symmetry without losing quotas?
inventor 2017
Thank you.

 

[stefanobruno]

Unfortunately there is no way.
the ease of obtaining the symmetric model breaks when recovering the table.

 

[graziano-g]

Hi, I didn't try, but I'd say it works, but it works, but I'm glad. .
if the component remains end to itself, which cannot be accepted in inventor as inventor, but the same thing applies to any parametric modeler, ie it will never need to be updated, what then to do is to generate from the idw its dwg that you will then open with acad, you will mirror it, you will eliminate the source design so you will save it with the new name. At this point the parameterization goes to copper, but you already know it without telling you, so for any updates you will have to repeat the procedure. the described operation is as dangerous as from process and as penalty previews the rage of the license, I know, but as extrema ratio and in the immediate it works.... most likely you are or are working in the vault or with an application type qs topinventor therefore what is said is to consider itself fried air that makes to shiver, if not I will evaluate it I tend to present that component must be careful in case of changes... Forgive heresy, but in some situation you could consider putting it into practice if nothing else to quickly advance the production then devote the right time to the table of the mirrored component, so much to those who cut or fold little interest in how the design was made, what will feed the machine is a geometry. Hi.

 

[stefanobruno]

ciao. ciao

I was watching a freak show, your text could have made a song.

 

[graziano-g]

hello, but unfortunately he's dead.... anyway, so I can understand too?? Thank you.

 

[Lacry77]

thanks to all