Gianp80
Guest
Hello everyone,
are at my first steps in complete autonomy with ansys r12.0, so (as it is logical that it is) begin to come out the first problems. . .
we say that the network provides enough material on the use of the software but does not clarify all the doubts that arise..... are therefore to ask for help to the experts present in this forum, because you know that experience is the fundamental basis of a correct design. ...
My questions may be answered in the following points:
1 - how do you check if the cad model is imported correctly?
2 - with what criterion are the elements for the meshatura chosen?
3 - how do loads and constraints correctly model (both in classic environment and in workbench environment)?
I thank in advance those who wish to participate in this discussion by providing their experience, so that I think they can give a big hand in understanding and using software to many people.
facts were not for viver as brutes but to follow virtute and canoscence
are at my first steps in complete autonomy with ansys r12.0, so (as it is logical that it is) begin to come out the first problems. . .
we say that the network provides enough material on the use of the software but does not clarify all the doubts that arise..... are therefore to ask for help to the experts present in this forum, because you know that experience is the fundamental basis of a correct design. ...
My questions may be answered in the following points:
1 - how do you check if the cad model is imported correctly?
2 - with what criterion are the elements for the meshatura chosen?
3 - how do loads and constraints correctly model (both in classic environment and in workbench environment)?
I thank in advance those who wish to participate in this discussion by providing their experience, so that I think they can give a big hand in understanding and using software to many people.
facts were not for viver as brutes but to follow virtute and canoscence