modeling soles

[umbo1987]

Good morning! ! !
following the advice of such gfrank in the realization of a compute I shaped the soles by dividing the rustic from the insulating and finishing package, now I have a question: the finishing package overlaps with the partition walls, now I have to draw these floors according to the boundary of the plots fearing that they happen disasters in case I want to change the dividers or is there another way? ? ?
Excuse me but a beginner! ! !
Thank you.

 

[umbo1987]

Please help me! !

 

[Tristan]

the advice you followed is not universally applicable. if it is only for the compute materials do not need to make this thread; If you have to demolish and rebuild it makes more sense. What exactly do you have to do?

 

[umbo1987]

Oh thanks tristan tvb!!!
I have to correctly shape a building and in particular at this moment I am trying to solve the problem of the partition wall knot, I have set the walls so that they leave from the structural insole, and I would like to realize a finish that does not overlap the wall but that it is net of this, possible that there is a tool that helps me as for example in the union between 2 walls where the layers outside of the core merge? ? ?
thank you so much tristan, sn 2 days that stand still for this problem!! !

 

[umbo1987]

I thought of drawing the second sole-finish net of the walls but then I'm afraid that changing the internal distribution I have to change the loft every time! Is that it?
- - - updated - - - -is a complex of almost 200 apartments, in the design phase

 

[Tristan]

can there be a tool that helps me as for example in the union between 2 walls where the layers on the outside of the nucleus merge? ? ?

You say that?
if you mean this just use the change command > join (indicated in the red circle)

 

[umbo1987]

Be! ! !
Thank you so much!!!! but now I have a question! as I am making a very big project there is the possibility to join all the walls together and not once at a time otherwise I don't end anymore?? above there is a check that says "uni.multipla" but I can't use it and then... so I am sure that the calculation of the areas of finishing surfaces es tile, plasters etc. is right? ?
I thank you!!! I know a beginner and often the answers I need in banality!

 

[umbo1987]

you were really nice!!! Thank you again!

 

[Tristan]

is there the possibility to join all the walls together and not once at a time otherwise do I not end??? above there is a check that says "uni.multipla" but I can't use it

no unfortunately, i.e. the multiple union allows you to select the loft first and then the multiple plots without always rechecking the floor, but still the walls always take one at a time.

so I am sure that the calculation of the areas of finishing surfaces es tile, plasters etc. is right? ?

- I'm sorry. .