molle ondulate

[Half65]

Good morning.
I have to do these two parts but I find it difficult because of certain mistake proceeding as you see.
Is there anyone who can give me a tip?

 

[mamobono]

Hi, look at this

ciao

 

[Half65]

solved following the example of solid modeling design. Thank you.

 

[Half65]

ciao, wait for this

ciao

this is even better because you can change everything in flight, thank you!

 

[AlbeLav]

Here's a model that does what you want.

 

[Half65]

Here's a model that does what you want.

it doesn't open me... it makes me choose and click but then nothing happens

 

[Half65]

ciao, wait for this

ciao

there is a problem with this system but... it is in the table setting; the above is done with the relationships while the below (more complicated to change) is done as indicated solid modeling design. the right table is the one under no doubt.

 

[mamobono]

Hi.
when you see in the table the purple color of the piece means that it is not a solid.
you must solidify it

Hi.

 

[Half65]

Hi.
when you see in the table the purple color of the piece means that it is not a solid.
you must solidify it

Hi.

You know how to do that would be nice. for now I have changed the thickness of the magenta pen and I have put it like white but I can't find in penne.pnt the pen!

 

[mamobono]

Since you created it in creo and it is not an import from stp it is very likely that the surfaces are closed.
just select all and

https://support.ptc.com/help/creo/c...part_modeling/about_the_solidify_feature.html

if they are open then you have to close them but it is another sport

Hi.

 

[Half65]

Thank you! !