hrodebert
Guest
Hello, I downloaded the demo of revit 2010 and as software I like very well if not very intuitive as archicad (which I usually use).
I managed to get to a discreet level thanks to the vs. forum and network tutorials only that now has been a while that I can not build a continuous facade.
I practically create the volume of the project that is a cone trunk, I divide it with a triangle pattern and realizes the lines that intersect only that to these lines I would like to apply the section of the profile that I usually use.
I would like to get to the continuous facade that you see in the program's start screen.
thanks for any interest.
I managed to get to a discreet level thanks to the vs. forum and network tutorials only that now has been a while that I can not build a continuous facade.
I practically create the volume of the project that is a cone trunk, I divide it with a triangle pattern and realizes the lines that intersect only that to these lines I would like to apply the section of the profile that I usually use.
I would like to get to the continuous facade that you see in the program's start screen.
thanks for any interest.