msg error on data export

[davide.f]

Hello everyone
I found a little problem working with the inventor suite 2009.
once put on the table my set go to save copy with name in dwg autocad format and I get out this error:
"Impossible to open the dwg model file. check the path and try again. "
the path is the same as the project. I've done a lot of tests, but it looks like I don't want to know how to work.

Has it happened yet?
Thank you.

 

[davide75]

try to save with export command

 

[Tarkus]

does something similar to me too:
save with autocad name-> dwg:
autocad opens it normally, but inventor doesn't open it anymore and from the message:
"to open autocad drawings a valid inventor design model is necessary."
which I believe means that he wants (also?) an inventor's dwg.
However little bad, the dwg are made by autocad and this opens them well...

 

[davide.f]

So... I discovered that it works by saving in dxf format, I could continue to work the same, but in dwg remains the problem and I don't understand why. I think it might be an automatic update downloaded for windows 7 64bit that may not be compatible with inventor..

 

[Ilario]

for both those with the problem: Check, in the dwg options that you have a valid path in the second screen below right on "model file placement".

 

[davide.f]

Thank you so much, trouble solved! I actually did an operation on that file I didn't remember anymore. Thank you!
Hello good holidays! :smile: