Hello
here illustrated in the photos my problem, I think so you can understand much better than explaining it, gives me this error in the first photo, then when I apply the surface remain holes due to the curve... How is it to close them?
thanks in advance to all!
Hello
here illustrated in the photos my problem, I think so you can understand much better than explaining it, gives me this error in the first photo, then when I apply the surface remain holes due to the curve... How is it to close them?
thanks in advance to all!
first thing you wrote in the wrong post... here we talk about catdrawing
apart from this smallness....... you must be sure that the sections
that you are using in the loft go to touch the lines (where you see the opening)
and then use the 2 lines as guidelines, perhaps giving
also the tangent to the surfaces you have already done, and
using also as guide the line you put in the middle
to the sections.
