multifoil table with 2 measuring units

[stefanodeutz]

Good morning, at the request of our American salesman, I need to send them drawings of our machines both in mm and in inches:-(
I wondered if there was a possibility in sw to differentiate the units of mis. on the two sheets so as to have a pdf export of one file with the two tables inch-e mm
thanks in advance

 

[MassiVonWeizen]

no, but you can change the unit to the quotas
procedure:
activates the quota filter
ctrl+a (check all about the set filter type)
property manager>sche other
overwrite units
type of unit

 

[stefanodeutz]

Thank you. That's what I needed.