multiforms

[warrel79]

Hello everyone

I happen to have to draw completely perforated sheets.
Obviously I use the serial function but problem is that the computer slows down a lot when I make these series and if I have to make any changes it takes a mess of time.
Isn't there a faster system? I tried to import the grid already made as dxf but equal.
the pc ' a hp workstation z400 with picture graphics card fx.

 

[davide75]

make a shared sketch on which to put the various hole centers in order to have them all in one sketch? ? So then you go to choose what kind of hole to do

 

[Ilario]

also looks in the options of the series the type of calculation.
sometimes solves the heaviness of calculation, but not always:

 

[Catafratto]

with "completely" perforated sheet, do you mean those sheets with, like, holes d.5 at step 15mm, all sheet, which are sometimes used to protect some parts of the machine? In this case by experience I advise you to make the holes in model 3d and to limit yourself to indicating it at the table.. .

 

[Tarkus]

follow the catafract board, if ever, if you want to see it on the solid model, use texures...

 

[Ilario]

Yes, right, in that case, as the "colleges" say;-)
My method is only when you need to make the laser sheet cut mandatory and you need to have 3d geometry, otherwise it doesn't need anything

 

[warrel79]

Yes, right, in that case, as the "colleges" say;-)
My method is only when you need to make the laser sheet cut mandatory and you need to have 3d geometry, otherwise it doesn't need anything

then yes, I mean the perforated plates but the holes are hexagons and not round.
cmq I had already thought to make only holes to indicate the encumbrance and then to indicate in the table .
the problem is if I have to cut them to the laser, but I think it's better to do them directly on the dxf before I get them in the car.

thanks to all

 

[Catafratto]

can also do the processing and then suppress it: you will find out when you export to dxf, while as long as you use the axieme you hold it suppressed to work better.

 

[stefanobruno]

you will find out when exporting to dxf

armed with patience, both in the phase of " discover processing " and in the adaptation of the table.
You also have the shortness to move the drilling as a last processing, so as not to bind the rest to the presence or not of the hexagonal hole machine.

 

[callaghan]

and use a punch..? ?