Abdessamad97
Guest
I have a problem I don't know how to spin the two gears
Do I need to use inventor studio?
or create a movement between the two?
Do I need to use inventor studio?
or create a movement between the two?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
volaff
Guest
I think you find the answer in the section "presentation"
PierArg
Guest
as you have already anticipated volaff and as from regulation you are invited to introduce yourself!
I see if it is the case of moving the discussion in the appropriate section because your question is about using the software and not a design problem
I see if it is the case of moving the discussion in the appropriate section because your question is about using the software and not a design problem
Abdessamad97
Guest
sorry is because it is the first time I use this site
PierArg
Guest
Yes, but presenting itself is a matter of education!
Abdessamad97
Guest
I'm sorry I wrote myself less than a month, I had a doubt about the release I don't know where the presentation is and neither did they.
PierArg
Guest
during registration it is required to read the regulation. Everything's written there.
You obviously didn't.
However, even if I do not want to read the regulation and not knowing how a forum works, I would be spontaneous to present myself.
you opened a post immediately shooting 2 questions as if the forum was an automatic response distributor.
and definitely not a good way to start.
You obviously didn't.
However, even if I do not want to read the regulation and not knowing how a forum works, I would be spontaneous to present myself.
you opened a post immediately shooting 2 questions as if the forum was an automatic response distributor.
and definitely not a good way to start.