notes fold v615

[c.buzzetti]

Hello, everyone.
I recently installed the v615 version.
today for the first time I put on the table some developments of sheet metal and I found the notes of small folds.
I tried to search everywhere but I couldn't set the height of the note.
I also tried to compare the configurations of v614, but they result = to those of v615.
Did someone do the same?
Can you help me?

Thank you very much.

 

[Tegliota]

Hello, everyone.
I recently installed the v615 version.
today for the first time I put on the table some developments of sheet metal and I found the notes of small folds.
I tried to search everywhere but I couldn't set the height of the note.
I also tried to compare the configurations of v614, but they result = to those of v615.
Did someone do the same?
Can you help me?

Thank you very much.

Hello buzzes
What do you mean "the notes of small folds"?
I apologize with everyone I signed up only today and since I use top solid, I was making a round and I met your request
greetings

 

[c.buzzetti]

in practice when I quote developments on a table for example in scale 1:5 the notes and quotas I insert are as high as I set them (in my case 3mm) the notes of the folds that indicate the fold angle instead are scaled 5 times. with the previous version instead these notes were like my setting 2.5 mm.
I hope I've been clear.

Hi.

 

[Tegliota]

in practice when I quote developments on a table for example in scale 1:5 the notes and quotas I insert are as high as I set them (in my case 3mm) the notes of the folds that indicate the fold angle instead are scaled 5 times. with the previous version instead these notes were like my setting 2.5 mm.
I hope I've been clear.

Hi.

I'm sorry
I attached a file and try to see if I understand what you were looking for... sorry you were clear I have doubts about what I did for you
greetings and good holidays

 

[Tegliota]

greetings
I wanted to know if I had been helping you or maybe I did a huge festry about your request
greetings and good holidays

 

[c.buzzetti]

settings are exactly like the file you attached to me.
I attach an image of how I find the note of the fold corners on a 1:5 scale table.
as you see the note "giu90" and "su45" are smaller than the odds. for precision are 0.4mm. since I set the 2mm notes are exactly scaled 1:5.

greetings and greetings