nx 8.5

[mori]

Hello, everyone, help me? :smile:. .
I imported my design from utocad 3d in nx, it consists of a structure in elevation and foundation how do I create the surfaces from the lines? create the surfaces I have to transform them into two distinct solids but coupled xkè by generating the mesh it must have continuity between the two solids, how do you do to do all this?
Thank you very much

 

[The_Matrix]

Hello, everyone, help me? :smile:. .
I imported my design from utocad 3d in nx, it consists of a structure in elevation and foundation how do I create the surfaces from the lines? create the surfaces I have to transform them into two distinct solids but coupled xkè by generating the mesh it must have continuity between the two solids, how do you do to do all this?
Thank you very much

I recommend importing autocad sections into sketches and then using normal modeling features (extrusions, revolutions, etc.).
once you create your solids, create mesh.
If you want to align the knots you have 2 ways:
1. put a mating condition between the two faces of the solids that touch (superior and lower for e.g.)
2. put between the 2 solids a "gluing" to make nx understand that the 2 models must have a continuity

 

[mori]

thanks to ugoverall for hosting me at the torino offices only for a day. but it is a pass