obtain casting from worked

[Filo]

of a piece that is obtained with processing on a fusion I have the ipt that is not derived from the fusion. the design of the fusion exists only in dwg. now I have to make also 3d of the fusion to have the idw.

Is there a smart way to get merge from the work? or, as I imagine, should I resign myself to make the 3d of the fusion and also the 3d of the work to derive it from the fusion?

Hi.

I remember reading something in the past, but I tried to break that discussion without success.

 

[eugenesis]

If you want the crude from the finite, simply do the derived part of the finite,
you can also give him the scale factor of the possible withdrawal (for the modeler..) , then put the "kick" you want with your
processing where you want overmetals (extrusion, move face, offset thickening etc.)
eliminate the bevels, the holes (with "elimina face" + mandatory repair flag) put the sforms etc.
There's no problem.
even if the correct road from the point of view of management is always the one that simulates reality;
that is to say, the fusion (great) is modeled and from this the finished work is derived, I note that a father
can have so many children, but a son has only one father or from a flock you can get finished different derivatives ..