orient sketch on inclined sections

[MARCOC]

caio to all, I have the following problem, at the table I do a section as from image that I move you, then I align the view in horizontal section to the drawing sheet, but when I do it a sketch above, the sketch remains adorned with the inclination of the section. I ask you and can tell him that the sketch must be aligned with the new ornamentation? ? ?

Thank you very much

 

[Biggmetals]

before you do the sketch, are you sure you have selected the view that interests you?
you understand it from the boxes; if you press the view in section also includes sketch? or in general with what view does your sketch also move?

 

[MARCOC]

If I move the section view, the sketch goes behind him.

 

[MassiVonWeizen]

You can't.
Can you make us worthy of an answer to your other questions?https://www.cad3d.it/forum1/threads/nascondi-parti-derivate.52860/https://www.cad3d.it/forum1/threads/spessore-lamiera-e-raggio-interno.52851/

 

[MassiVonWeizen]

in the end just make a relationship of parallelism/perpendicularity between the edge of the sketch and one of the edges of the model

 

[MARCOC]

excuse Massivon, I answer immediately