origin table holes do not delete

[MARCOC]

bungiorno to all... in the table, once inserted the hole table, the source indicator appears rightly, the problem and that once deleted the table, the indicator can only hide it, but no longer cancels?? ? ? ?

someone to ideas, I don't think it's correct not to be able to erase

Thank you very much

 

[pagnotz]

I have never found a way to eliminate it (probably it is not possible), at most when possible I came back with annulment.

 

[Zac69]

in fact you can not delete it, but only hide and reappear eventually to reuse it or move it.
Also for each view you can have a single source indicator.
at the bottom of a hidden indicator is not all this mischief according to me.

 

[pagnotz]

Yes, it is not a big problem, but go to remember a tomorrow that is there but is hidden. . .

 

[davide75]

never hide it! It can happen that if you hide it and then maybe you do a revision of the design the indicator can move inadvertently but you do not notice why it is hidden. to us once it happened and I don't tell you the mess

 

[Zac69]

I say if you don't need to hide. if you enter a new inventor holes table you will notice that there is already (although hidden) and no longer asks you to place it. at this point potions the table, then you make it visible again and the positions where it is necessary.

 

[davide75]

I repeat that if you do a revision not necessarily tied to holes you can have trouble. example success to us: drilling table for a sheet plate with indicator on a edge, hidden indicator. design went into revision as we had to put a bevel just where the indicator was hooked (hidden) that because of the bevel he married going to change all the odds of the holes.of course who changed the design was not the same that he had quoted it the first time and therefore did not care. Of course, nothing came back from that moment we didn't hide it anymore.

 

[Zac69]

I repeat that if you do a revision not necessarily tied to holes you can have trouble. example success to us: drilling table for a sheet plate with indicator on a edge, hidden indicator. design went into revision as we had to put a bevel just where the indicator was hooked (hidden) that because of the bevel he married going to change all the odds of the holes.of course who changed the design was not the same that he had quoted it the first time and therefore did not care. Of course, nothing came back from that moment we didn't hide it anymore.

Of course everyone is free to do what they want. but if you have a hole table you can always make it visible again for a control.

 

[davide75]

Yes, it is enough that those who do the revisions know it and if you remember that if you do not go to touch the holes the origin you can move the same.magari with the visible symbol is more immediate to realize it. and however it can be extra safety when the design is given to some supplier who immediately sees where the origin symbol is and can discover any discrepancies.